Table Des Matières - Pioneer A-70-K Mode D'emploi

Operating Environment
Operating environment temperature and humidity:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or
strong artificial light)
If the AC plug of this unit does not match the AC
outlet you want to use, the plug must be removed
and appropriate one fitted. Replacement and
mounting of an AC plug on the power supply cord of
this unit should be performed only by qualified
service personnel. If connected to an AC outlet, the
cut-off plug can cause severe electrical shock. Make
sure it is properly disposed of after removal.
The equipment should be disconnected by removing
the mains plug from the wall socket when left unused
for a long period of time (for example, when on
vacation).
CAUTION
The /I STANDBY/ON switch on this unit will not
completely shut off all power from the AC outlet.
Since the power cord serves as the main disconnect
device for the unit, you will need to unplug it from the
AC outlet to shut down all power. Therefore, make
sure the unit has been installed so that the power
cord can be easily unplugged from the AC outlet in
case of an accident. To avoid fire hazard, the power
cord should also be unplugged from the AC outlet
when left unused for a long period of time (for
example, when on vacation).
This product is for general household purposes. Any
failure due to use for other than household purposes
(such as long-term use for business purposes in a
restaurant or use in a car or ship) and which requires
repair will be charged for even during the warranty
period.
D3-4-2-1-7c*_A1_En
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power
cord when your hands are wet as this could cause a
short circuit or electric shock. Do not place the unit, a
piece of furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed such that they
are not likely to be stepped on. A damaged power cord
can cause a fire or give you an electrical shock. Check
the power cord once in a while. When you find it
damaged, ask your nearest PIONEER authorized
service center or your dealer for a replacement.
D3-4-2-2-1a_A1_En
D3-4-2-2-2a*_A1_En
Thank you for buying this Pioneer
product.
Please read through these operating instructions so that
you will know how to operate your model properly. After
you have finished reading the instructions, put them in a
safe place for future reference.
K041_A1_En
Contents
01 Before you start
What's in the box. . . . . . . . . . . . . . . . . . . . . . . . . . 4
Loading the batteries in the remote control . . . . . . 4
Using the remote control. . . . . . . . . . . . . . . . . . . . .4
Installing the amplifier . . . . . . . . . . . . . . . . . . . . . . 4
02 Connecting up
Making cable connections. . . . . . . . . . . . . . . . . . . 5
About "Bi-wiring" . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Connecting speaker cables . . . . . . . . . . . . . . . . . . 6
Connecting audio cables . . . . . . . . . . . . . . . . . . . . 6
Using centralized control with other Pioneer
components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Digital audio input connections (A-70 only) . . . . . . 6
S002*_A1_En
Using a USB cable to connect to a computer
(A-70 only) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Plugging in . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
03 Controls and displays
Front panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Rear panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . 10
04 Operation
Playback . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Set the power to Standby. . . . . . . . . . . . . . . . . . . .11
When using the unit as a power amplifier . . . . . . .11
Playing music from a digital audio component
(A-70 only) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Playing music from a computer (A-70 only) . . . . . .12
Making an audio recording . . . . . . . . . . . . . . . . . 12
To set for automatic standby status
(Auto Power Down) . . . . . . . . . . . . . . . . . . . . . . . 13
Restoring all the settings to the factory default
settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
05 Additional information
Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . 14
Cleaning the unit . . . . . . . . . . . . . . . . . . . . . . . . . 14
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
3