Abus Secvest ESMO50000 Instructions D'installation Et D'utilisation page 29

Installation
Using the mobile communication module
If the alarm panel is already in operation, put the panel into installation
mode. This ensures that opening the housing will now not trigger a
sabotage alarm.
Note
Open the housing of the alarm panel.
1.
Disconnect the alarm panel from the power supply. To do this, disconnect both
2
the external power supply (unit / 230 V connection) and the backup batteries.
Only for FUAA50xxx: Carefully remove the ribbon cable which connects the key
panel/touch panel and the motherboard.
Lead the antenna cable from the outside through the cable openings in the
3
back panel into the inside of the housing. Secure the antenna outside the
housing.
Connect the mobile antenna to the mobile communication module (see figure).
4
Insert the SIM card into the card holder of the mobile communication module
5
(see figure).
The PIN code of the SIM card must be switched off or set to "0000".
Equip the mobile communication module with the supplied plastic holders. Now
6
carefully place the mobile communication module on the plug connectors of the
motherboard and press down firmly. Ensure that the pins do not get bent. (See
figure)
Only for FUAA50xxx: Now reconnect the key panel/touch panel to the
7
motherboard.
Reconnect the power to the alarm panel, and reattach the (backup) battery.
Reconnect the (backup) battery and reconnect the alarm panel to the mains
supply.
29