Beveling Tool - Bevel Tools Bevel Mate ABA-12 Mode D'emploi

Use only Beveling tools whose admissible maximum speed is equal to or higher than the no load speed of the
machine.
Use only clean tools!
Changing a Bevel Head

Disconnect tool from air supply.

Turn the Flange head to its maximum depth. (Fig. 2)

Lock spindle with the locking button. (Fig. 3)

Use the Hex wrench (5mm) to unscrew the guide bearing. (Fig. 3)

Take the bevel head off.
Bevel Head
Fig. 1
Tool
Fitting a Bevel Head

Before fitting the Bevel head clean the surface of the adapter and Bevel Head.

Check the guide bearing, it should run smoothly, a guide bearing that doesn't run smoothly will damage the
Bevel head and can lead to a broken Bevel Head.

Place Bevel Head on the adapter, the pin on the adapter should easily fit into the pinhole in the Bevel
Head.

Lock spindle with the locking button. (Fig. 3)

Use the Hex wrench (5mm) to tighten the guide bearing. (Fig. 3)

Check if the Bevel head runs smoothly and true, not true running Bevel heads must be replaced
immediately.
Check Bevel tool before use. The Bevel head must be correctly mounted and must rotate freely. Perform a trial run
a minimum over a period of 30 seconds without load. Do not use Bevel Heads which are damaged, which do not run
true or which vibrate!

BEVELING TOOL

Guide
Bearing
5mm
Wrench
Fig. 2
EN
Fig. 3
8