Safety Instructions; Safety First - Bevel Tools Bevel Mate ABA-12 Mode D'emploi

Safety first!

In order to use air tools properly and safely, the user must read carefully and understand these instructions
before operation. Keep this instruction manual at a best place near the working area for reading and referring
before operation. Be careful not to remove the warning labels attached to air tools.
Wear proper clothing and protectors

Always wear the proper clothing for safe operation (Fig.1).

Do not wear loose clothing that may be affected because the RPM of air
tools.

Wear a safety cap to protect the head scalp and hairs.

Wear safety eyeglasses, which should be consisted of an impact proof
lens.

Wear a mask for protecting against the dust and particles which are
generated during the operation and which are harmful for your health.

Wear an ear protector to prevent noise damage and preserve your hearing
ability.

Wear safety shoes.

Take a time for relax when operators are tired.

Do not touch the rotating wheel when in operation.
Working area and environment

Keep working area clean and be careful not to slip on oily or slippery surfaces.

Keep away from flammable or explosive liquids or gaseous, that can cause fire by the spark generated
during operation.

Do not operate power tools in the explosive atmosphere which is likely to blow up.

According to the operating condition, noise or vibration is generated. Be sure to wear ear and hearing
protection that conforms to all the local regulations.
Proper operation

Be sure that the air pressure is supplied at the rated pressure for proper performance of the tool.

Be sure that cutting heads, screws, bearings and attachments are tightened up before operation. If not,
grinders can be broken by the vibration and it is very dangerous.

When attaching the accessories at the tools, check the attached state. When handling air tool parts, be
careful not to touch the sharp edge.

Never use a bevel head which is broken, twisted, defective etc. broken parts of grinder during operation
are very dangerous to machines as well as operators.

When replacing the beveling head, be sure that the air is turned off and the hose is disconnected.

Operate in a proper and comfortable posture, an unstable and improper posture can cause pain to an
operators hand, feet and waist. Always use two hands to control the machine.

Do not shock, drop down or throw air tools as precision parts can break. Strong shock can cause failure by
the broken and twisted parts.

Do not use air tools for abnormal operation. Be sure that operation is within the air tools capacity. Do not
use air tools for other purposes except instructed.

Bring the machine slowly into contact with the work piece only after the maximum tool speed has been
reached.

When cutting a bevel always move the machine from left to right against the direction of rotation of the
.
milling head

When machining bore holes, always work in a clockwise direction.

Take Beveling machine from work piece and turn off.
EN

SAFETY INSTRUCTIONS

5
Fig. 1