Safety Instructions; Safety First; Proper Operation - Bevel Tools Bevel Mite ABIS-06 Premium Mode D'emploi

Safety first!

In order to use air tools properly and safely, the user must read carefully and understand these instructions before
operation. Keep this instruction manual at a best place near the working area for reading and referring before
operation. Be careful not to remove the warning labels attached to air tools.
Wear proper clothing and protectors
·
Always wear the proper clothing for safe operation (Fig.1).
·
Do not wear loose clothing that may be affected because the RPM of
air tools.
·
Wear a safety cap to protect the head scalp and hairs.
·
Wear safety eyeglasses, which should be consisted of an impact proof
lens.
·
Wear a mask for protecting against the dust and particles which are
generated during the operation and which are harmful for your health.
·
Wear an ear protector to prevent noise damage and preserve your
hearing ability.
·
Wear safety shoes.
·
Take a time for relax when operators are tired.
·
Do not touch the rotating wheel when in operation.
Working area and environment
·
Keep working area clean and be careful not to slip on oily or slippery surfaces.
·
Keep away from flammable or explosive liquids or gaseous, that can cause fire by the spark generated
during operation.
·
Do not operate power tools in the explosive atmosphere which is likely to blow up.
·
According to the operating condition, noise or vibration is generated. Be sure to wear ear and hearing
protection that conforms to all the local regulations.

Proper operation

·
Be sure that the air pressure is supplied at the rated pressure for proper performance of the tool.
·
Be sure that cutting heads, screws, bearings and attachments are tightened up before operation. If not,
grinders can be broken by the vibration and it is very dangerous.
·
When attaching the accessories at the tools, check the attached state. When handling air tool parts, be
careful not to touch the sharp edge.
·
Never use a bevel head which is broken, twisted, defective etc. broken parts of grinder during operation
are very dangerous to machines as well as operators.
·
When replacing the beveling head, be sure that the air is turned off and the hose is disconnected.
·
Operate in a proper and comfortable posture, an unstable and improper posture can cause pain to an
operators hand, feet and waist.
·
Do not shock, drop down or throw air tools as precision parts can break. Strong shock can cause failure by
the broken and twisted parts.
·
Do not use air tools for abnormal operation. Be sure that operation is within the air tools capacity. Do not
use air tools for other purposes except instructed.

SAFETY INSTRUCTIONS

5
Fig. 1