Gaggenau AI 220190 Mode D'emploi page 33

Installing the lower support frame
•
Attach upper and lower parts of the support
frame at the specified total height with
10 screws (preferred hole selection, see
diagram).
•
Ensure that the lower support frame is in the
correct position. The open side must be facing
the hob control.
NOTE: The support frame can be aligned
subsequently by loosening the fastening screws on
the ceiling.
Installing the extractor hood
1 Hook the extractor hood from below into the
support frame.
Do not trap the power cord!
2 Attach the extractor hood to the support frame
with 2 securing screws.
Exhaust-air
mode
700-880
Circulating-air
mode
700-1000
3 Hook in retaining clip and screw tight.
4 Connect the pipes.
5 Connect the power supply.
33