Assembly / Setup; Fuel - Texas A/S GT 301 Mode D'emploi

4. Assembly / Setup

The handle should be mounted such that you obtain the best possible work position. Pull
the handle back and forth, until you find the best position.
Push the handle in over the shaft, and fasten it with the included flange nut.
Figure 2
Mount shield as shown in picture.
Figure 3
Control that the air filter is wetted in oil. If not, then pour a bit of two cycle oil on the air
filter. Squeeze excess oil out, see point 10.

5. Fuel

- This product is equipped with a two stroke engine which requires two stroke
lubricating oil to be added to the gasoline.
- Always use lead free gasoline (minimum 95 octane)
- Do not use pre-mixed gasoline/oil from gas stations intended for mopeds, motor
cycles etc.
- Always follow directions supplied by oil supplier regarding mixing ratio (look on the
back panel of can).
- Use a clean and approved gas can for mixing oil into gasoline.
- Use an approved 2 stroke oil approved for air cooled motors, chain saws, trimmers,
etc. (Do not use oil intended for outboard motors or motor oil for cars). Mix small
amounts.
- Typically 2% oil is mixed into the gasoline. (Mixing ratio 50:1) However, always
follow manufacturer's instructions on back panel of can.
- Mix oil and gasoline thoroughly, and shake gas can every time before filling fuel on.
Do NOT use a gasoline mixture which is more than 90 days old, since it can cause
problems starting engine. Do not store mixed gasoline in tank for more than 30
days.
For long term storage tank should be emptied.
-
www.texas.dk
15