Prior To Taking The Machine Into Service; Rating Data; Operating Conditions; Protection Devices - Bevel Tools Bevel Mite EBI-C 3.0 Mode D'emploi

i

2.1 Prior to taking the machine into service

Working with worn or damaged bevel heads will cause the machine to fail.
• Check bevel head prior to use.
• A sharp bevel head will increase cutting speed and machine life.
• The bevel head must be changed regularly.
• The bevel head must be mounted correctly see 3.2.1
• Observe national regulations.
2.2.1 Turn on
!
• Always wear protective clothing, safety shoes, safety glasses
and ear protection.
• Make sure you always have a firm footing when working with
the machine.
• Whatever the position of the machine, always use two hands
to control the machine.
• Never touch the bevel head when the machine is running.
• Never use the machine above head height.
• The machine should only be used for conventional up-cut
milling.
• To turn the machine on, push the ON/OFF switch
the front.
• Bring the machine slowly into contact with the work piece
only after the maximum speed has been reached.
• When cutting a bevel, always move the machine from left to right against the rotation direction of the bevel head.
• When machining bore holes, always work in a clockwise direction.
2.2.2 Turn off
• Take beveling machine from work piece and turn off by pressing the back (B) of the ON/OFF switch.
• Motor stops.

2.3 Rating data

No-load speed
Max. wheel diameter
Grinding spindle thread
Sound pressure level according to EN 60745
Noise emission level
Vibration according to EN 60745
Battery capacity
Voltage
Weight w/o battery pack
The specified vibration value was measured with a standardized test procedure. It can be used to compare products or
to make an initial assessment of the exposure. The vibration emissions may differ from the specified value, depending
on how the power tool is used. Operating personnel must be protected with defined safety measures based on the
estimated exposure under the actual conditions of use (these must take into account all phases of the operating
cycle, e.g. the times when the power tool is switched OFF and the times it is switched ON, but is not under load).

2.4 Operating conditions

Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.1 Protective devices
The machine may only be operated with the flange head mounted.
EN
B
(A) toward
8600 min-1/rpm
24 mm
M6
81,6 dB (A) K = 3 dB
92,6 dB (A) K = 3 dB
0,5 m/s2 K = 1.5m/s2
5.0 Ah
18 V
2.6 kg
3
A