Prior To Taking The Machine Into Service; Working Area And Environment; Proper Operation; Recommended 'Minimal Air Supply Setup - Bevel Tools Bevel Mite ABIS-B 3.0 Mode D'emploi

2.1 Prior to taking the machine into service

i
• Working with worn or damaged bevel heads will cause the machine to fail.
• Check bevel head prior to use.
• A sharp bevel head will increase cutting speed and machine life.
• The bevel head must be changed regularly.
• The bevel head must be mounted centrally and positioned against the limit stop.
• The maximum allowable speed of the tool and of the chuck may not be exceeded under any circumstances.
• Observe national regulations.

2.2.Working area and environment

!
• Keep working area clean and be careful not to slip on oily or slippery surfaces.
• Keep away from flammable or explosive liquids or gaseous, that can cause fire by the spark generated during
operation.
• Do not operate air tool in an explosive atmosphere which is likely to blow up.
• According to the operating condition, noise or vibration is generated. Be sure to wear ear and hearing protection
that conforms to all the local regulations.

2.3 Proper operation

!
• Always wear protective clothing, safety shoes, safety glasses and ear protection.
• To achieve an optimum bevel result, move beveling tool uniformly with light pressure.
• Excessive pressure lessens the working capability of the machine, as well as the life of the bevel head.
• Be sure that the air pressure is supplied at the rated pressure for proper performance of the tool.
• Be sure that the air used is lubricated. For oil specifications see § 2.4 When air is not lubricated please add a
drop of oil every 4 hours into the air input.
• Be sure that bevel heads, screws, bearings and attachments are tightened up before operation. If not, grinders
can be broken by the vibration and it is very dangerous.
• When attaching the accessories at the tools, check the attached state. When handling air tool parts, be careful not
to touch the sharp edge.
• Never use a bevel head which is broken, twisted, defective etc. broken parts of grinder during operation are very
dangerous to machines as well as operators.
• When replacing the bevel head, be sure that the air is turned off and the hose is disconnected.
• Operate in a proper and comfortable posture, an unstable and improper posture can cause pain to an operators
hand, feet and waist.
• Do not shock, drop down or throw air tools as precision parts can break. Strong shock can cause failure by the
broken and twisted parts.
• Do not use air tools for abnormal operation. Be sure that operation is within the air tools capacity. Do not use air
tools for other purposes except instructed.

2.4 Recommended 'minimal air supply setup'

Compressor
Compressor tank
Air Dryer
Air consumption ABIS-R = 22 CFM | 0.62 m3/min.
Recommended user supply:
Min. 25 CFM | 0.71 m3/min
Air pressure: max 6.3 bar / 91 PSI
Use high flow connectors and 12-13mm hose for
best results
EN
Filter|Regulator|Lubricator unit (FRL)
10 CentiStokes OIL