Touch-Sensor Switch; Clock And Date Adjustment - AEG BMG 5677 Mode D'emploi

English
98
Do not let battery fluid get into your eyes. If it should get in your eyes, immediately
rinse with plenty of clean water and contact a physician.
Power supply operation
You can operate the device also with a power supply unit (power supply unit not
included in the scope of delivery).
When using a power supply unit, take care that the listed voltage matches the
voltage of the outlet. Also check that the output current and the polarity of the power
supply unit match the data on the sphygmomanometer. (Power supply unit output:
DC 6 V, 600 mA,
Before operating the device with a power supply unit, make sure that the device is
switched off and that no batteries have been inserted. Do not disconnect the power
supply unit while operating the device.
a. Plug the power supply unit into a correctly installed safety socket.
b. Connect the device to the power supply unit by inserting the plug of the power
supply unit into the DC 6 V socket (back of the monitor).
If the device is not to be used for some time, disconnect the power supply unit from
the outlet. Also pull the plug of the power supply unit from the DC 6 V socket of the
device.
The monitor, the batteries and the cuff, must be disposed of according to local
regulations at the end of their usage.

2. TOUCH-SENSOR SWITCH

Your monitor has six touch buttons as equipment. Be careful
not to touch the screen by mistake. Keep the touch buttons
switch in "OFF" position when the monitor is not in use to
avoid unintentional operation.

3. CLOCK AND DATE ADJUSTMENT

You can only set the date and time if the monitor is switched off.
a. Press the button " ", the year will blink at first. Press the button „ " repeatedly,
the month, day, hour and minute will blink in turn. While a number is flashing, press
the button "M" to increase the number. Hold the button "M" depressed, the num-
ber will increase rapidly.
)