AEG SLS 4705 Mode D'emploi & Garantie page 38

Connection
Note: Please ensure that the plug connections are fi rm.
Bad connections may lead to poor sound quality.
1 2CH INPUT
Used for connecting an external sound source via
cinch (e.g. hi-fi video recorder).
2 5.1CH INPUT
Used for connecting an external sound source to a
5.1 output (e.g. DVD player).
3 AUDIO OUTPUT
Outputs on the right and left for connection of the
front loudspeakers (FRONT RIGHT/ LEFT).
Output for connection of the centre loudspeaker
(CENTER).
Output for connection of the surround loudspeakers
on the right and left (REAR RIGHT/ LEFT).
4 Mains lead
Correct connection is as follows:
When you have connected all loud speakers and devices
as described you can insert the mains plug of the sub-
woofer into a correctly installed 230 volt, 50 hertz power
socket.
38
05-SLS 4705 AEG neu2 38
Optional Connection of the Rear or
Front Loudspeakers to the Transmitter
1 SCAN
Button for activating the channel search
2 Standby control lamp
3 AC 230 V / 50 Hz
Mains lead
4 R OUT / L OUT (RIGHT/LEFT)
Loudspeaker output (right/left)
5 POWER ON / OFF
On/off switch
6 DC 5V IN Connection socket
7 AUDIO IN
3.5 mm jack socket audio input
8 FREQUENCY SELECT Button
For resetting the channel
9 POWER Control lamp
10 ON / OFF
On/off switch
11 VOLUME
Volume control
12 Foot
General Information
• The audio signals are sent from the transmitter to the
receiver. The range within buildings is approximately
30 m. The range may be less, depending on the
ambient conditions.
• The audio signals are transmitted in the 2.4 GHz
range.
• Compression-free high sound quality with 0.5 ms
delay time.
• The audio signals are processed digitally at a samp-
ling rate of 44.1 KHz and 16 bits.
• If the transmission is affected by interference or poor
reception, the device activates the muting function
(see section on "Poor Reception Quality").
14.02.2006, 9:02:35 Uhr