AEG SLS 4705 Mode D'emploi & Garantie page 37

General safety instructions
To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug so-
cket. Pay attention that the specifi ed voltage corresponds
to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries in
the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should the
device become damaged, in particular the mains supply
cable, do not operate the device any longer, but rather
have it repaired by an expert. Check the mains supply
cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove
the plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompanying
documentation.
Special safety information
• In order to ensure your children's safety, please keep
all packaging (plastic bags, boxes, polystyrene etc.)
out of their reach.
Caution! Do not allow small children to play with the
foil as there is a danger of suffocation!
Installation
• Remove all devices from the packing and replace the
internal packaging material back in the box.
• Retain the packaging if possible during the entire
guarantee period!
• Do not insert the plug of the subwoofer into the socket
until all loudspeakers and connections have been
correctly made!
05-SLS 4705 AEG neu2 37
For optimum installation of the loudspeakers, please
follow the instructions below:
Installing the Loudspeakers
1. Connect the base plate to the loudspeakers with the
fastening materials supplied.
2. Now connect the loudspeaker cable supplied to the
loudspeaker. Ensure the correct polarity (connect
black to black and red to red).
3. The cinch plug of the loudspeaker cable is now
connected to the AUDIO OUTPUT of the subwoofer
according to the loudspeakers.
4. For optimum surround sound the tweeters of the front
loudspeaker columns can be rotated to a certain
degree.
Caution: In order not to damage the swivel joint it
should not be turned further than the limit stop (ap-
prox. 45°).
Installation of the Front Loudspeakers
Note:
• Illustration 2: The protective rubber edges must be
removed before installation.
• When lifting the fl oor-standing loudspeakers please
hold them only by the bottom third as otherwise the
swivel joint may be damaged.
37
14.02.2006, 9:02:34 Uhr