INTERTECHNO ITL-1001 Mode D'emploi page 20

GB
The wireless pulse switch ITL-1001 switches off automatically after two
seconds and has a potential-free output, making it ideal for remotely
controlling garage door drives, door and gate openers with a switching
capacity of up to 1000 watts.
The pulse switch is intended for surface or flush mounting.
The fastening straps can be broken off to save space when installing in a
flush-mounted box Fig. 1
Compatible with all intertechno wireless transmitters manufactu-
red in 1995 or later.
Mounting (only to be carried out by a qualified electrician):
1.) Turn off the main fuse.
2.) The connections must be made as in Fig. 2 for potential-free opera-
tion e.g. for controlling garages or doors, or as in Fig. 3 for 230 volt
connections.
Coding (Fig. 4 )
Please also observe the operating instructions for your transmitter.
3.) Turn on the fuse again and have the desired transmitter ready to
hand.
The learn button (L) can now be turned on to check the connecti-
ons, with a brief press (without transmitter) using a pointy object
(e.g. paperclip, ballpoint pen).
4.) By long-pressing (approx. 2-3 seconds) the learn button (L) the LED
will flash slowly, the radio receiver is then ready to code the transmi-
tter.
5.) Press the ON button on the transmitter.
The wireless receiver will switch twice to confirm that the new code
has been accepted.
The encoding is now complete.
Operating instructions
ITL-1001
›