Troubleshooting - Green Machine GM15520 Manuel D'utilisation

 Put a few firm strokes on every tooth. File all left hand
cutters in one direction. Then move to the other side and
file the right hand cutters in the opposite direction. Oc-
casionally remove filings from the file with a wire brush.
CAUTION:
Dull or improperly sharpened chain can cause excessive
engine speed during cutting, which may result in severe
engine damage.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Bar and chain running hot and
smoking.
Engine starts and runs, but chain is
not rotating.
MAINTENANCE
ATTACHING THE STORAGE HANGER
See Figure 24.
There are two ways to hang the attachment for storage.
 To use the hanger cap, push in the button and place the
 The secondary hole in the attachment shaft can be used
STORING THE ATTACHMENT
 Clean the attachment thoroughly and lubricate before
 Store the attachment indoors in a dry, well-ventilated
 Keep away from corrosive agents such as garden chemi-
 Always place the scabbard on the cutting blade before

TROUBLESHOOTING

CAUSE
Check chain tension for overtight con-
dition.
Chain oil tank empty.
Chain tension too tight.
Check guide bar and chain assembly.
Check guide bar and chain for
damage.
11 — English
hanger cap over the end of the attachment shaft. Slightly
rotate the cap from side to side until the button locks into
place.
for hanging purposes as well.
storing.
place that is inaccessible to children.
cals and de-icing salts.
storing or when the attachment is not in use.
Tension chain. Refer to Chain Tension
earlier in this manual.
Check oil tank.
Retension chain, Refer to Chain Tension
earlier in this manual.
Refer to Replacing the Bar and Chain
earlier in this manual.
Inspect guide bar and chain for damage.
REMEDY