Operation; Applications; Preparation For Cutting - Green Machine GM15520 Manuel D'utilisation

Accessoire d'élagage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Align the button with the guide recess on the extension
shaft coupler and slide the two shafts together. Rotate
extension shaft until button locks into the positioning hole.
NOTE: The attachment should only be operated with the
blade in a vertical position. If the button does not release
completely in the positioning hole, the shaft is not locked
into place. Slightly rotate from side to side until the button
is locked into place.
 Tighten the knob securely.
 Repeat previous steps to attach extension shaft to power
head.
WARNING:
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use
to avoid serious injury.
To remove:
 Stop the engine and remove the spark plug wire.
 Loosen the knob.
DANGER:
Never cut near electric cords or lines. If bar and chain
jams on any electrical cord or line, DO NOT TOUCH THE
BAR, CHAIN, OR SHAFTS! THEY CAN BECOME ELEC-
TRICALLY LIVE AND VERY DANGEROUS. Lay down the
power head away from you in a safe manner. Disconnect
the electrical service to the damaged line or cord before
attempting to free the bar and chain from the line or cord.
Contact with the bar, chain, shafts, other conductive
parts of the power head or pruner attachment, or live
electric cords or lines will result in death by electrocution
or serious injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, as well as hearing and head
protection, when operating this equipment. Failure to do
so could result in objects being thrown into your eyes and
other possible serious injuries.
ASSEMBLY
 Push in the button and twist the shafts to remove and
separate ends.
INSTALLING THE SHOULDER STRAP AND
STRAP HANGER
See Figures 3 - 4.
When operating this unit, you must wear a shoulder strap to
support the unit. If your unit does not have a strap hanger
installed on the power head shaft, use the following instruc-
tions to install the hanger.
 Pull strap hanger apart and place over power head end
of shaft; position near the upper knob.
 Install bolt, washer, and lock nut. Tighten nut securely.
NOTE: Check for tightness before each use to avoid
serious injury or product damage.
 Place shoulder strap over your left shoulder and attach
shoulder strap clip to strap hanger. Adjust by sliding the
front clip up or down.
NOTE: When properly adjusted, the power head should
be supported by the shoulder strap about hip level.

OPERATION

WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:
 Limbing
 Pruning

PREPARATION FOR CUTTING

 Wear non-slip gloves for maximum grip and protection.
 Maintain a proper grip on the unit whenever the engine is
running. Use your right hand to firmly grip the rear handle
while your left hand has a firm grip on the front handle.
 Hold unit firmly with both hands. Always keep your left
hand on the front handle and your right hand on the rear
handle, so your body is to the left of the chain line. Never
use a left-handed (cross-handed) grip, or any stance that
places your body or arm across the chain line.
 Never stand directly under the limb you are cutting.
 Always wear shoulder strap for increased safety and to
support the pruner.
7 — English

Publicité

Table des Matières
loading

Table des Matières