Battery Installation; Alarm Setting - LEXIBOOK Barbie RPB060 Mode D'emploi

Battery installation

1. Open the battery door located under the unit.
2. Insert 3 x 1,5V
the polarity indicated in the battery compartment.
3. Replace the battery compartment.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be
removed from the product before being charged. Rechargeable batteries are only to be
charged under adult supervision. Different types of batteries or new and used batteries are not
to be mixed. Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed
from the product. The supply terminals are not to be short circuited. Do not throw batteries into
a fire. Remove the batteries if you are not going to use the product for a long period of time.
WARNING: Mal-function or loss of memory may be caused by strong frequency interference or
electrostatic discharge. Should any abnormal function occur, reset the unit or remove the batteries
and insert them again, or unplug the AC/DC adapter from the mains socket then plug it back.
CLOCK AND DATE SETTING
1. In clock mode (time and date display), press and hold the SET key until the hour's digits start flashing.
2. Use the UP and DOWN keys to increase or reduce the values, then press SET to confirm and
adjust the next setting.
3. The setting sequence is displayed in the following order:
Hours Minutes
4. Press the SET key to confirm your settings. The unit goes back to clock mode.
Note:
• When setting the date, the weekday is selected automatically.
• When adjusting the hours and the minutes, if you do not press any key for 10 seconds, the unit will
automatically go back to clock mode.
• When adjusting the year, the month, the date and the 24hr/12hr display, you need to press SET to
confirm the values and go to the next setting.

ALARM SETTING

1. In clock mode, press the SET key once to go to the alarm setting.
2. Press and hold the SET key until the hour's digits start flashing.
3. Use the UP and DOWN keys to adjust the hour, then press SET to confirm and adjust the minutes.
4. Use the UP and DOWN keys to adjust the minutes, then press SET to confirm and go to the next
setting.
5. Use the UP and DOWN keys to select the alarm type. You can wake up with one of the 20 preset radio
stations from "01" to "20. Or if you select "BEEP", you will wake up with the regular alarm ringtone.
6. Press the SET key to confirm the new settings and go back to the alarm time display.
7. Use the UP and DOWN keys to switch on or switch off the alarm then, press the SET key to
confirm and go back to clock mode. When the alarm is switched on, the
the LCD screen.
8. When the alarm rings, press the MODE, SET, UP or DOWN keys to stop it. The alarm will ring
again the next day at the same time.
LR6/AA type batteries (not included) observing
Year Month Date
9
24hr/12hr display
icon is displayed on