Warranty; Disposal And Environmental Aspects - Saci pumps ejoy Manuel D'installation Et D'entretien

Message
ALARM F06
MOTOR FAULT
ALARM F07
LOW WATER LEVEL
ALARM F08
MAXIMUM PRESSURE
LIMIT
ALARM X13
INTERNAL ERROR

12. WARRANTY

The guarantee on the speed variator is 24 months from the date of purchase: The use of non-original spare parts,
alterations or improper use shall render the product warranty void.

13. DISPOSAL AND ENVIRONMENTAL ASPECTS

To dispose of the parts that comprise the speed variator, you must abide by the current regulations and laws of the
country where the product is used. In any case, do not dispose of polluting parts into the environment.
This symbol on the product indicates that it should not be disposed of with other household waste.
This stipulation only refers to the disposal of equipment within the European Union (2012/19 /EU). It is the user's
responsibility to dispose of the equipment by delivering it to a designated collection point for the recycling and
disposal of electrical equipment. For more information about equipment collection points, contact your local waste
disposal agency.
Reasons
The motor is communicated/disconnected.
Loss of synchronism.
The variator detects that the pump is working
without water in the body of the pump.
The variator detects that the filter is very
soiled or at a pressure close to bursting.
There is no communication between the
control panel (cover), and the power plate
(radiator).
Internal fault in the variator.
Check that the cables to the motor are properly connected, as the
variator is not detecting the motor, or it is burnt out.
There may also be a loss of synchronism of the motor during
operation due to a significant, quick change in the pumping
conditions.
Ensure the pump aspirates the fluid correctly.
Check the filter does not need cleaning and that the impulsion
valves allow recirculation.
Check that the flat cable that communicates both electronic
circuits are well connected and tightened.
There may be one-off read error of the firmware. We recommend
cutting the power to the variator for a few minutes. If, when the
power is reconnected to the variator, the message remains,
contact your nearest technical service.
32
EN
Solution(s)