Kenwood KDC-BT268U Mode D'emploi page 32

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Orientate the trim plate
as illustrated before
fitting.
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
28 ENGLISH
Do the required wiring.
( 29)
Hook on the top side
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes on both
sides of the trim plate, then pull it out.
3 Insert the extraction keys deeply into the slots on each side,
then follow the arrows as shown on the illustration.
Dashboard of your car
Part list for installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key