Konig Computer CMP-COMPCASE20 Mode D'emploi page 3

LCD panel displays introduction
A. TIME
Real-time clock or continuous running hours of PC display, which can be switched by
touching TIME icon for 2s minimum.
1. How to set and adjust clock time
1.1. Switch TIME display to real-time clock mode.
1.2. Touch TIME icon area gently, the 2-digit hours will blink, press +/UP to
increase or -/DOWN to decrease to desired hours.
1.3. Press SET to confi rm, and the other 2-digit minutes.
1.4. Press +/UP or -/DOWN until you get the right minutes.
B. HDD
Hard-drive status display. The icon will blink when hard disk is accessed.
C. +/UP
To increase clock time or system fan startup temperature.
D. POWER
Power switch.
E. SET
To confi rm the settings.
F. RESET
Reset switch. Returns to its original state.
G. -/DOWN
To decrease clock time or system fan startup temperature.
H. TEMPERATURE
CPU working temperature display. The fan will run automatically to exhaust the heat
generated inside the case when the CPU temp. rises above the preset temp.
1. How to set the startup temperature of system fan.
1.1. Touch TEMP icon area gently, the temperature digits will fl ash.
1.2. Press +/UP to increase or -/DOWN to decrease to your desired temperature
at which the cooling fan will start up.
1.3. Press SET to confi rm and exit the setting.
I. FAN
Show the working status of system fan. The fan will start auto and the icon will revolve
when CPU temp rises above the preset temp. You may adjust fan speed between low/
medium/high by touch FAN icon area when the fan is working.
J. UNLOCK
To unlock touch screen to make all switches operatable. Always press UNLOCK fi rst to
activate the switches for any on-screen operation.
K. LOCK
To lock the touchscreen to avoid careless mis-touch or being disturbed by others. In this
mode, no switches can be operated.
3