SOLAC HU1052 Mode D'emploi page 7

The device has the following modes:
•
Humidifier
Press the On / On
Off button once
Press the On / On
Off button twice
Press the On On
/ Off button 3
times
Press the On Off
/ Off button 4
times
If there is insufficient water in the tank, a red
•
light will blink and steam generation will stop.
In this case, it will be necessary to d refill the
tank with water before turning the device back
on.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Unplug the appliance from the mains.
•
Remove the water from the water tank.
•
Clean the appliance.
•
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the electrical equipment and the mains
•
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid or
•
base pH such as bleach, or abrasive products,
for cleaning the appliance.
Never submerge the appliance in water or any
•
other liquid or place it under running water.
Never submerge the connector in water or any
•
other liquid or place it under running water.
If the appliance is not in good condition of
•
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
Then dry all parts before its assembly and
•
storage.
There may be some scale deposits in the
•
transducer, particularly in areas with hard
Light water:
- Overcome this drawback by cleaning the
Changeable
transducer.
(7 colours)
- Rub down with a dry cloth and remove
remains of moisture.
Fixed
- Do not place the transducer directly under
(1 colour)
the tap.
No
- Do not rub the transducer with hard or metal
objects.
- Do not clean with chemical products.
Off
HOW TO DEAL WITH LIME SCALE
INCRUSTATIONS:
For the appliance to work correctly it should
•
be kept free of limescale or magnesium
incrustations caused by the use of hard water.
To prevent this kind of problem, we recommend
•
the use of water with low lime or magnesium
mineralisation.
However, if it is not possible to use the kind
•
of water recommended above, you should
periodically remove the limescale from the
appliance:
- Every 6 weeks if the water is "very hard".
- Every 12 weeks if the water is "hard".
A specific anti-lime scale product should be
•
used on this kind of product.
Fill the tank with water plus the anti-lime
•
product, leave about 30 minutes, drain and
clean with water.
Homemade solutions are not recommended in
•
the decaling of this appliance, such as the use
of vinegar.
RECOMMENDATIONS
Never leave water in the base or in the tank.
•
Note: Water accumulated over long periods
•
may create bacteria and mildew (fungus).
Dry all the parts inside the appliance carefully,
•
paying particular attention to the transducer.
Store the appliance in a cool, dry place.
•
EN