Product Installation - Fracarro OPT MBJ ottici Mode D'emploi

Fix the product by using the three proper fixing points to the wall or use the coupling to
the DIN rail to ensure the proper dissipation of heat. To make the installation easier, use
the following template:
LED
Power LED
Remote feeding LED
LED of input RF level
LED of received optic power
LED Lock status of the RF signal available on the receiver Indicates that the antenna signal is connected to the
LED of the RF output level

PRODUCT INSTALLATION

PRODUCT TEMPLATE
120mm
DESCRIPTION
It indicates that the product is power supplied.
The UHF input of the OPT-3US-TX and the T+S input
of the OPT-T+S-TX-PLUS are fed remotely. If the LED
is off and the remote supply is enabled, it means that
a short circuit is occurring or that there is an
excessive absorption on the input.
It indicates the total RF level of each input in the
operating range.
It indicates that the received optic power is in the
operating range.
optical transmitter
It indicates that the total RF output level is kept
constant at the nominal level. Please consider that the
LED can be off even if there is the RF signal when the
optic power is at the minimum. In that case, the total
RF output level can be slightly lower than the nominal
value.
11