Troubleshooting - Ryobi P325 Manuel D'utilisation

CLEARING A JAMMED FASTENER
See Figure 12, page 15.
WARNING:
Remove the battery pack from the tool before clearing a
jammed fastener. Failure to do so could result in serious
personal injury.
Driving too deeply into the material, excess debris, or jammed
nails may lead to the driver mechanism being stuck at its
bottom position.
The driver mechanism can usually be returned to its operating
position by depressing the work contact element against a
scrap piece of wood and squeezing the trigger.
If this does not automatically return the driver mechanism
into the tool, the tool may be jammed.
PROBLEM
Work-contacting element does not
depress fully - tool does not operate.
Tool operates properly, but fasteners do
not drive fully
Tool operates properly, but fasteners are
driven too deep
Tool jams frequently
Tool stops and LED flashes rapidly
Tool has charged battery and LED is
slowly flashing or LED does not turn
off after approximately ten seconds of
non-use.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 12
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION

TROUBLESHOOTING

POSSIBLE CAUSE
Low nails
Work-contacting element is jammed
Air pressure is too low
Depth of drive isn't deep enough
Nail is too long for wood hardness
Air pressure is too high
Depth of drive is too deep
Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Battery is low or has no charge.
Trigger released too early
Tool has malfunctioned
ILLUSTRATIONS START ON PAGE 13.
11 — English
If a nail or fastener becomes jammed in the tool, remove
the battery pack and keep the tool pointed away from you
while clearing the jam.
 Remove battery pack from the tool.
 Remove fasteners from the tool.
 Pull up on the latch and open the jam release.
 Insert a flat blade screwdriver into the tip of the driving
mechanism and push the driver mechanism back, freeing
the nail jam.
 Remove the bent nail.
 Close the jam release and latch.
 Reinstall nails.
 Reinstall the battery pack and reactivate tool.
Replenish nails
Remove battery and clear debris
Increase air pressure
Adjust depth of drive
Use nail length that is appropriate for
wood
Decrease air pressure
Adjust depth of drive
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Recharge battery
Remove battery and reinstall.
Take tool to nearest authorized repair
center
SOLUTION