Loading Tool - Ryobi P325 Manuel D'utilisation

 Do not hold the tool by the front of the magazine. Do
not put hands, head, or other parts of your body near the
bottom of the magazine where the nail exits the tool, as
serious personal injury could result.
 Do not point the tool toward yourself or anyone
whether it contains nails or not.
 Do not actuate the tool unless you intend to drive a
nail into the workpiece.
 Always ensure that the workpiece contact is fully
positioned above the workpiece. Positioning the
workpiece contact only partially above the workpiece
could cause the nail to miss the workpiece completely
and result in serious personal injury.
 Do not drive nails near edge of material. The workpiece
may split causing the nail to ricochet, injuring you or a
co-worker. Be aware that the nail may follow the grain
of the wood, causing it to protrude unexpectedly from
the side of the work material or deflect, possibly causing
injury.
 Keep hands and body parts clear of immediate work
area. Hold workpiece with clamps when necessary to
keep hands and body out of potential harm. Be sure
the workpiece is properly secured before pressing the
fastener against the material. The workpiece contact may
cause the work material to shift unexpectedly.
 Keep face and body parts away from back of the tool
cap when working in restricted areas. Sudden recoil
can result in impact to the body, especially when nailing
into hard or dense material.
NAILER SAFETY WARNINGS
5 — English
 During normal use the tool will recoil immediately
after driving a fastener. This is a normal function of
the tool. Do not attempt to prevent the recoil by holding
the nailer against the work. Restriction to the recoil can
result in a second fastener being driven from the nailer.
Failure to heed this warning can result in serious personal
injury.
 Do not drive fasteners on top of other fasteners or with
the tool at an overly steep angle as this may cause
deflection of fasteners which could cause injury.

LOADING TOOL

 Do not load the tool with fasteners when any one of
the operating controls is activated.
When loading tool:
 Never place a hand or any part of body in fastener
discharge area of tool.
 Never point tool at anyone.
 Do not pull the trigger or depress the workpiece
contact as accidental actuation may occur, possibly
causing injury.
SAVE THESE INSTRUCTIONS
 Refer to them frequently and use them to instruct others
who may use this tool. If you loan someone this tool, loan
them these instructions also.