Loading Cartridges into the Magazine
16
Chapter 2 Operation
Setting 8 cartridges into the magazine
It is recommended that all 8 cartridges be used as recording media.
Depending on the application software, a cleaning cartridge can be set in
place of one of the data cartridges. The sequence in which cartridges are set
into the magazine determines the numbers by which they are managed as
indicated in the figure below.
Numbers of data cartridges inside the magazine
(Setting 8 cartridges into the magazine)
Setting 7 cartridges into the magazine
Numbers of data cartridges inside the magazine
(Setting 7 cartridges into the magazine)
Note:
If cartridges are not loaded in one of the arrangements indicated in the
figures, the magazine will eject. The cleaning cartridge can only be used in
the 8 position.
Setting 1 cartridge into the magazine
Either a data cartridge or cleaning cartridge can be loaded into the 8 position.
Numbers of data cartridges inside the magazine
(Setting 1 cartridge into the magazine)
Note:
If no cartridge is loaded into the position indicated above, the magazine is
ejected.