Operating - Vimar CO Stop 20422 Instructions D'installation

3. Operating

3.1 Turning on the detector
When the detector is turned on (power is provided),
the three LEDs light simultaneously for about 1s and,
after a brief signal they turn off and then come back
on according to the code of the detector.
Then the detector warms up for about 1 min. During
this time the commands to the solenoid valve and
buzzer are inhibited. This phase is signalled by the
simultaneous flashing of the yellow
LEDs.
12 - ENGLISH
3.2 Regular operating
Note
The detector is operating correctly when the green LED
flashing.
If there is any irregularity or if the device fails the green LED
shifts to constant mode
and green
("Irregularities").
Once the warm-up time is finished the yellow LED
turns off while the green LED
cating that the detector is operating regularly.
or turns off (see the paragraph
starts flashing indi-
is