SOLIS OEKOTHERM L1623 Mode D'emploi page 68

SOLIS Bettwärmer-oeko-engl.-GROSS_2013 09.07.13 15:59 Seite 68
S T O R A G E A N D M A I N T E N A N C E
▲
ATTENTION: Always let the bed warmer cool down
completely before folding and storing it.
Do not place anything on the bed warmer and do
not crumple it for storage.
• The storage space should be dry, clean and not exposed to direct sunlight.
• Over time, your bed warmer might take on a slightly yellow tinge. This is abso-
lutely normal and has no influence on the functionality of your bed warmer.
W A S H I N G Y O U R B E D W A R M E R
▲
• The easy to clean-material and removable control element with power plug al-
low for cleaning of the bed warmer by hand or on a delicate wash cycle. Use a
mild detergent and do not exceed 40°C (Choose a low spin cycle!). To remove
the control element, press the two protrusions on the left and right side of the
connection jack and pull away the connection plug.
Connection jack Adaptor
Please note: Power plug, connection adaptor on the power cord and control
element must never come into contact with water!
• Let the bed warmer dry out completely on a large towel.
• Tip: Measure your bed warmer before washing it and occasionally stretch it while
it is still moist to assure that it returns to its original size.
• After washing, check the heating wires for damage by holding the bed warmer
against the light.
• Plug the connection adaptor back into the jack. The bed warmer must only be
operated with the included control element.
68
press to disconnect