SOLIS OEKOTHERM L1623 Mode D'emploi page 67

SOLIS Bettwärmer-oeko-engl.-GROSS_2013 09.07.13 15:59 Seite 67
ATTENTION: Should you intend to lie down on
the bed warmer, do not activate warmth level 6!
Prolonged use while level 6 is selected might cause
burns to sensitive skin!
4 . P R O L O N G E D U S E , F. E . O V E R N I G H T
• In case you have pressed the FAST HEAT button, you have to turn off the pre-
warming function by pressing the FAST HEAT button again. Depending on
what warmth level was selected before activating the FAST HEAT function or swit-
ching off the appliance, the display will state an orange figure between 1 and
5.
• Press the temperature selection button
1 and 5.
• The corresponding figure will illuminate orange in the display. The higher the fi-
gure, the warmer the appliance will become.
•
If you wish to operate the appliance for prolonged periods of time or over
night, please select a warmth level between 1 and 5. Use level 6 only for
pre-warming.
• Please note: The bed warmer will take up to 15 minutes to reach the set tem-
perature. After 15 minutes, please check with the back of your hand to see if
the temperature still is pleasant.
Memory function:
• When your appliance has been running for a few minutes, it will memorise its
last setting and start in it when switched on another time.
Automatic deactivation function:
• You bed warmer is equipped with an automatic deactivation function. After
9 hours, the appliance will automatically switch off and the warmth level cho-
sen last will flash in the display. In this state, the control element is disabled. To
reactivate the appliance, either turn the ON/OFF switch on the backside to „0",
then to „I" or press the FAST HEAT button.
S W I T C H I N G O F F T H E A P P L I A N C E
▲
• To switch off the appliance, turn the ON/OFF switch on the backside of the con-
trol element to the „0" position. Then, pull the power plug from the socket.
to select a warmth level between
67