Taurus ONTIME CLASSIC Manuel D'utilisation page 11

Anomalies
The pressure regulating valve is noisy
and doesn´t expel steam after heating
the pressure cooker.
The safety valve expels vapor or
liquid.
The pressure valve does not rise
The lid does not close properly
- Take the appliance to an authorised technical support service if problems
arise. Do not try to dismantle
or repair without assistance, as this may be dangerous.
Ecology and recyclability of the product
- The materials of which the packaging of this appliance consists are included
in a collection, classification
and recycling system. Should you wish to dispose of them, use the appropriate
public
recycling bins for each type of material.
The product does not contain concentrations of substances that could be
considered harmful to the
environment
This appliance complies with Directive 97/23/EEC on Pressure Vessels.
Manual Ontime Classic.indb 11
Causes
(1) Tamponade the valve pressure control
(2) Tamponade tube air vent
(3) Cooking without liquid
(4) Tilt the stove
(1) Clogging of the air outlet pipe
(2) The pot is overfilled
(3) The heat source is too strong
(1) The lid is not fitted correctly
(2) The heat source is not powerful enough
(3) The seal is dirty, damaged or deformed
(4) Not enough water
The lid is deformed
Solutions
(1) Clean the pressure control valve
(2) Remove the dirt.
(3) Turn off the stove immediately, remove the
pressure cooker, reduce the pressure and check
the pot.
(4) Heat the pan on a flat, stable stove
(1) Remove the dirt
(2) Reduce the filling quantity
(3) Adjust the heat source to the steam being
released by the pressure valve.
(1) Fit it correctly
(2) Increase the heat
(3) Clean or replace the seal
(4) Check the amount inside the pressure cooker
Change the lid
22/6/15 17:34