Pet Mate CAT MATE 360 Mode D'emploi page 4

9. Fitting Instructions (See Figs. 7 to 11)
Wood / Plastic / Metal Door Panels
NOTE - N. America only: This flap is not suited to 10 digit FDXA microchipped pets in
combination with METAL panels.
9.1 Place the exterior frame in desired position on panel and draw round the outside
of the tunnel section as shown in Fig. 7. We recommend the bottom of the hole
is approximately level with your pet's stomach.
9.2 Use an electric jigsaw to cut 2mm (
cut hole square to the door, particularly with thicker doors. Ensure frames are
free-fitting in hole.
9.3 Determine thickness of door panel.
9.4 For door panels 3mm ( / ") - 25mm (1") thick:
1
8
9.4.1 Position exterior frame on outside of door and mark four screw positions
(Fig. 8).
9.4.2 Remove frame and carefully drill screw clearance holes square to panel at
6mm ( / ") diameter (Fig. 9).
1
4
9.4.3 For panels less than 17mm (
(G) as shown in Fig. 10 with a hacksaw or plastic cutting disc.
9.4.4 Fit seal (J) to exterior frame. Position exterior frame on outside of door.
Screw interior frame to it by using 37mm (1
caps (Fig. 11).
9.5 For door panels 25mm (1") + thick:
9.5.1 Carefully drill out four holes in interior frame to allow close clearance on
screws (recommended drill 5mm (
9.5.2 Fit seal (J) to exterior frame. Screw exterior frame to outside of door using
13mm ( / ") screws.
1
2
9.5.3 Screw interior frame to inside of door using 22mm (
screw caps.
Metal Panels (including plastic coated metal)
After fitting, ensure the flap is tuned to the metal panel by pressing the PROGRAM
button (H) for 5 seconds until LED (A) lights. After 10 seconds press the PROGRAM
button again to complete retuning.
Walls / Glass Panels
For easy installation you will require an adapter kit available from your cat flap supplier
or direct from Pet Mate (Product Ref. 361).
/ ") outside of drawn line. Be careful to
1
16
") thick, cut excess liner from exterior frame
/
5
8
/ ") screws. Finally, fit screw
1
2
/ ") diameter) as shown in Fig. 12.
3
16
/ ") screws. Finally, fit
7
8
6
10. Troubleshooting
10.1 Red LED (A) flashing
• 1 flash every 30 seconds indicates need to replace alkaline batteries.
• 2 flashes every 30 seconds indicates cleaning required (See Section 8).
• Random flashing indicates changes in light level or need to clean cat flap (See
Section 8).
10.2 Flap does not open in response to programmed I.D. Disc or microchip
• Check 4 WAY lock is set to permit access in the chosen direction.
• Check catch (D, Fig. 1) moves freely up and down.
• Clean cat detector lenses and tunnel (See Section 8).
• Check batteries are correctly orientated (Fig. 3) and not in need of replacement
(See Section 6).
• Check I.D. Disc is correctly fitted to cat's collar.
• If possible, try operation with another programmed I.D. Disc / microchip to
ascertain if there is a fault with a particular I.D. Disc / microchip.
• Check cat flap is mounted at correct height (See Section 9).
• If all else fails, remove one battery and wait a minimum of 5 minutes. Refit
battery and then check if flap functions correctly. If not perform a FACTORY
RESET (See Section 7) before reprogramming (See Section 3).
7