Recharging The Battery; Technical Specifications - MELICONI HP DIGITAL PRO Mode D'emploi

Table des Matières

Les langues disponibles

To use the product normally, it is sufficient to switch the headphones on and off exclusively by using button "A" (press

for 3 seconds to switch on, press for 5 seconds to switch off)

When the headphones are not in use, it is advisable to switch them off, to avoid completely draining the battery, then

place them correctly on the charging dock (see the paragraph "Charging the batteries"), so that the battery will be

charged the next time you use them.

In the absence of an incoming audio signal, the charging dock automatically switches off after around 5 minutes (the

green indicator light "I" goes out).

If the headphones will not be used for a long period of time, it is advisable to unplug the AC adapter from the wall outlet

and recharge it every 4-6 months to prevent trickle discharge.

Position the headphones (receiver) on the recharge contacts of the charging dock (transmitter) to recharge the internal

battery;

Note: the headphones may be placed on the charging dock facing in any direction.

The red "I" (POWER/CHARGE) LED light will come on to confirm that the headphones are correctly positioned on the

charging dock; the light will turn green when the headphones are fully charged.

The initial charge will take at least 4-5 hours.

It is possible to charge the headset also through its own micro-usb socket "F", during the recharge the led "E" will be on

in red, when the recharge is finished it will turn off.

Transmission mode

Frequency Range:

RF output Power

Transmitter power supply

Frequency response

Distortion

Signal/noise ratio

Maximum transmission distance

Headphone charging time

Integrated lithium battery

Operating time of the headphones

Operating temperature

Transmission delay (latency)

Use