MELICONI HP DIGITAL PRO Mode D'emploi page 16

HEADPHONES (Receiver) Fig.1 and Fig.2
Headphone details:
A. On-off button
B. Volume adjustment buttons
C. MUTE button
D. Recharge contacts
E. Blue LED light
F. Micro-USB recharging socket
G. 3.5 mm jack input
CHARGING DOCK (Transmitter) Fig.3 and Fig.4
Charging dock details:
H. Recharge contacts for the headphones
I. "Power/Charge" LED light
L. "Audio Mode" LED light
M. Audio input selector: OPTICAL / RCA or 3.5mm
N. Stereo audio input for 3.5 mm jack cable
O. Audio RCA (L-R) input
P. Digital Optical Audio Output (Toslink)
R. AC power supply input
S. Pairing button
• Remove the headphones (receiver) from the charging dock
• Connect the AC adapter cable to the connector "R" on the back of the charging dock.
• Connect the AC adapter to the power outlet.
• The green LED "I" (POWER/CHARGE) on the charging dock lights up for one second, then it flashes orange indicating
the absence of the headset on the charging dock.
CONNECTION OF THE BASE TO THE AUDIO SOURCE (after recharging the HEADPHONES)
• Remove the headphones from the charging dock.
• Before making any connections, ensure that the source device is switched off.
• Depending on the type of audio output available on your device, connect the charging dock to the preferred audio
source using the appropriate cable.
• If the charging dock is connected using the Toslink optical table, move the "M" selector on the side of the charging
dock to "Optical".
• Remove the silicone protections at the two ends of the optical cable provided, and insert one of the two ends into the
"P" (OPTICAL IN) input on the back of the charging dock.
• If the analogue cable with 3.5 mm jack (also included in the pack) or the RCA connector (not included) is used, move
the "M" selector to "RCA/3.5 mm" and insert the end of the cable into the pertinent input: "N" for audio cable with 3.5
mm jack, "O" for RCA cable.
• Now connect the other end of the audio cable to the source device (e.g. TV or Decoder)
• Turn on the audio source (e.g. TV)
• Remaining near the charging dock, switch on the headphones (receiver), holding the "A" button down for about 3
seconds, until the blue "E" LED light comes on.
• After a few moments, the green "I" (POWER/CHARGE) LED light on the charging dock will flash twice; three audio
tones in the headphones and the permanent switching on of the green "I" (POWER/CHARGE) LED light will confirm
the completion of pairing between the charging dock and the headphones.
• Put on the headphones and use the two buttons "B" to increase or decrease the volume and obtain proper sound
reproduction.
• If the headphones fail to reproduce the sound, or if there is audio interference, please consult the "TROUBLESHOOTING"
section.
• Pressing the "C" button repeatedly will deselect the headset audio ("MUTE" mode):
- Mute ON : LED "L" lit with orange light
- Audio Playback : LED "L" lit with blue light
14
Installation