"Calc'nclean" Function - Bosch Sensixx'x DA70 EasyComfort Notice D'utilisation

25ml
20
B O SC H
C

"Calc'nClean" function

The "Calc'nClean" function helps to remove scale
particles out of the steam chamber.
If the water in your area is very hard, you may use this
function approximately every two weeks.
1 Set the steam regulator (5) to the position
Unplug the iron from the mains socket.
Tip: For deep descaling, it is recommended to use the
descaling liquid (see "Accessories" section). This
procedure should be carried out every 3 months.
Pour a measure (25 ml) of the descaling fluid into the
water tank.
2 Fill the water tank up to the level mark for maximum
45º
filling.
3 Plug in the iron.
4 When the lamp "TempOK" (1) remains lit continuously,
unplug the iron (very important!).
5 Hold the iron over a sink.
6 Press the "clean" button (9) and shake the iron back
and forth keeping it in a horizontal position until
approximately one third of the water capacity of the
tank is evaporated. Boiling water and steam will
come out, carrying scale or deposits that might be
there.
7 Release the "clean" button, and gently shake the iron
for some seconds.
8 Repeat steps 6 and 7.
9 Check carefully that the water tank is empty (very
important!).
10 Plug the iron in and heat it up again until the
remaining water has evaporated.
11 Unplug the iron and let the soleplate cool down. Wipe
the soleplate with a damp cotton cloth only.
.