Moving Your Appliance - Domo DO913DV Mode D'emploi

MOVING YOUR APPLIANCE

· If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will
allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile
parts (shelves, accessories, etc.) or fix them into the freezer to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it standing
upright for at least 10 minutes.
· Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly
and natural gas, it is explosive. Therefore you should be careful during shipment and installation
to prevent your appliance's cooler elements from being damaged. In the event of a leak caused by
damage to the cooler elements, move your fridge from open flame or heat sources and ventilate the
room where the appliance is located for a few minutes.
DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician.
Before you reverse the door, you should ensure the appliance is unplugged and empty. It is recommended
to use a crosshead screwdriver and a spanner (both not supplied).
1. Remove the 2 screws on the back of the top cover.
.
2. Lift the top cover away from the fridge.
3. Remove the three screws and then remove the top hinge that holds the door in place. Lift the door
and place it on a padded surface to prevent it from being scratched.
4. Remove the bottom screw, hinge bracket and adjustable foot from the bottom of the appliance.
5. Remove the adjustable foot from another side of the bottom and transfer it to the corresponding
position on the opposite side of the bottom.
www.domo-elektro.be
33
DO913DV