Ayce 2717 Manuel D'utilisation page 46

c. LED worklight (Fig. 5)
Fig.
5
d. Selecting the speed (Fig. 6)
Fig. 6
e. Switch on and off (Fig.7)
Fig. 7
180731_ayce_2717_IM
The tool has LED light to illuminate the
work area and improve vision when
working in areas with insufficient light.
The LED light will switch on automatically
while the on/off switch is turned on.
With the speed controller, the rate of
oscillation can be selected (also during
operation). Rotate the speed controller to
choose the suitable speed.
The optimum speed depends on the
material and should be determined by
carrying out a practical test.
• Stage 1: slow Stage 6: quick
• Hold the tool firmly to control the
twisting of the tool.
• To prolong the life of the tool never
overload it.
• To turn the tool ON, push the on/off
switch forward. To turn it OFF, push
the switch backward.
3. Operation for working
a. Sanding
Do not touch the gear box after prolonged use; it could be very hot.
!
WARNING
• The removal rate and the sanding pattern are determined by the choice of sanding
sheet and the work surface.
• Apply uniform sanding pressure to extend the life of the sanding sheets.
• Intensifying the sanding pressure does not lead to an increase of the sanding
capacity, but instead it increases wear on the machine and the sanding sheet.
• Use only the tip or an edge of the sanding sheet for precise sanding of edges,
corners and hard to reach areas.
• When selectively sanding on one spot, the sanding sheet can heat up considerably.
Remove the tool from the surface periodically to permit the sanding sheet to cool
down.
• A sanding sheet that has been used for metal should not be used for other
materials.
• Use only original sanding accessories. For sanding, always connect dust
extraction.
b. Scraping
The tool is suitable for scrapping and removing surface coverings. For scraping, select
a high speed setting.
• To remove surface covers, place the scraping blade vertically on the work-piece
• Switch the tool on and cut down through the covering.
• Place the tool at a flat angle (not over 20°) and apply alight forward pressure to
remove the covering.
c. Cutting
Saw blades are ideal for making precise cuts in tight areas, close to edges or flush to a
surface.
• Select the lowest speed for making initial plunge, start off at lowest speed for
increased control. After making your initial cut, you can increase speed for faster
cutting ability.
• Flush cutting blades are intended to make precise cuts to allow for installation of
flooring or wall material. When flush cutting, it is important not to force the tool
during the plunge cut. If you experience a strong vibration in your hand during the
plunge cut, this indicates that you are applying too much pressure. Back the tool
out and let the speed of the tool do the work. While keeping the teeth of the blade in
the work surface, move the back of the tool in a slow sideways motion. This motion
will help expedite the cut.
90 91 | GB
GB
180731_ayce_2717_IM