Putting Into Operation - ABICOR AIPLAS WELD 250 MT Mode D'emploi

6 Putting into operation

6 Putting into operation
6.1 Equipping the torch body
Fig. 4 Steps of equipping the torch body ABIPLAS
EN - 10
the inert gas or the active gas components. The cable assembly serves as a
supply line and is equipped with all connection elements.
This chapter gives you all the information that must be taken into account when
putting the device into operation.
DANGER
Risk of injury due to unexpected start-up
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the gas supply.
• Pull the mains plug.
NOTE
• The ABIPLAS
operation by trained personnel.
ABIPLAS
2-4
1
®
WELD 250 MT welding torches may only be put into
®
WELD 250 MT
5-7
3mm
®
WELD 250 MT
®
ABIPLAS WELD 250 MT
7-10