Assembling; First Ride - Ninebot S Mode D'emploi

4

Assembling

1 Insert the knee control bar into the steering
socket at the back of the mainframe.
Once installation is complete, stand the vehicle body up and perform a power ON/OFF check:
Press the power button to light up the display panel. Your Ninebot S beeps, indicating it's powered on successfully. Press the
power button again and then the dashboard turns off, indicating your Ninebot S powered off
of the Ninebot S is pre-set as unactivated. When it's power on, the Ninebot S will continue to beep if there is someone
standing on the foot mat, and both speed and sensitivity will be very limited. An unactivated Ninebot S cannot be used
immediately. Install the App on your mobile device and activate it following the instructions in the App.
5 Charging
Charging Port
•Do not puncture or open the enclosure, avoid contact to the battery terminals with any metal objects. Which may cause
electric shocks, lead to death or loss of warranty.
•Do not charge the battery if the ambient temperature is below 32°F (0°C) or above 104°F (40°C) to extend the life of the
battery and the charger.
7
2 Align and tighten the two 3 Snap the lid securely with hearing
screws by hex wrench. the sound of "click".
successfully.The factory setting
Open the charging Open up the
rubber cover of
port cover plate
the charging port
6

First Ride

1 Download and install the App. Register and then
login.
3 In App, click Vehicle > Scan for Vehicle > select
your Ninebot S, you will hear "beep" if succeed, the
Bluetooth icon on the dashboard will be ON.
Insert the plug
Once successfully connected, operate strictly
into the
according to the instructions in the App.
charging port
4 If the vehicle emits intermittent beeping during
use, connect to the App and check the reason.
There are safety risks for your first ride. You should only use it with the training.
Download and install the App on your mobile device with an AndroidTM or iOS system. You must
read the Safety Instructions and only use the Ninebot S after new rider training has been completed.
Search for Segway-Ninebot in the App Store or scan the QR code to download the App.
To pair Ninebot S with your phone
2 Power on. The Bluetooth icon on the dashboard
keeps flashing indicating that the Ninebot S waits
for connection.
8