Replacement Rope Bridges - TEUFELBERGER treeMOTION evo Mode D'emploi

Masquer les pouces Voir aussi pour treeMOTION evo:
Table des Matières

Publicité

rePlacement roPe BrIDges

cHart no. 1
Art. no. 7350158 (length: 123 cm) / 7350170 (length: 180 cm)
If you would like to replace the rope bridges exactly as they were before,
make sure to measure the distance between the knots on the rope bridges
that are to be removed before actually removing them!
1A: Untie the knot of
the upper rope!
1E: Introduce the
unknotted ends of
the first rope bridge
from inside to outside
through the elliptical
holes of both front D
rings.
8
1B: Untie the knot of
the lower rope!
1C: Remove both
ropes.
1F: Repeat 1E using the second rope bridge. This
is to be of contrasting colour. Make sure that the
ropes are equally positioned on both sides, i.e. the
one rope that is on top in the right front D ring must
be on top in the left front D ring. Do not forget to
put the sliding T ring on to one or preferably both
rope bridges (the rope bridges should be of equal
length). The ring may also be attached to one rope
bridge only. Alternatively one sliding T ring may be
used on each rope bridge. The ropes must not be
twisted and they must be fully parallel.
1D: Repeat on the sec-
ond side!

Publicité

Table des Matières
loading

Table des Matières