QUNDiS Q module 5.5 Instructions De Montage page 13

1. Remove the temporary cover to open the space for the add‑on
radio module
2. Remove possible foreign matter from the space for the
add‑on radio module
3. Unpack the add‑on radio module
4. Adjust the battery chamber of the add‑on radio module to the
space in the water meter
5. Place the add‑on radio module in the space
6. Fasten the add‑on radio module with the included screw
(TORX Plus 6IP)
When using a torque screwdriver:
– tighten until the limit is tripped (0,35 Nm)
When using a conventional screwdriver:
– tighten until the red LED lights
– the screw should be tightend further, by a maximum of half
a turn
– Until activation of the measuring function, the LED lights
up uninterrupted for 30 seconds.
Activation of the measuring function is signalled for one hour with
flashing of the LED diode.
7. The screw must be secured with the adhesive seal.
8. Align the counter for optimal readout.
18.08.2016
Sécurité et garantie
FIM5‑00MO‑DES‑RWMMO
Mounting
en
13