Log Data - Kemper 611 00 Manuel D'utilisation

EN
6
A FLOG folder is created on the SD card. This
contains two additional folders, which are
automatically named or assigned according to
the CAN IDs.
 the controller ID – for the logs that were
generated before the logger was plugged
in,
 the ID of the data logger in which
everything is stored once the logger is
connected.
Parameter
Timestamp
Cooling Buffer Temp (S1)
PWC Direct Flow Temp (S2)
PWC Return Flow Temp (S3)
S4
PWC Return Flow Rqr Temp
PWC Direct Flow Rqr Temp
Cooling Buffer Pump (R1)
Cooling Circulation Pump (R2)
R3
24/ 64 – K410061100000-00 – 07.2020 – © www.kemper-olpe.de

Log data

Two CSV tables are created in each subfolder.
• The MLOG.CSV serves as an event log, in
which all error messages and parameter
changes are documented.
• The LOG.CSV stores the following opera-
ting parameters:
Description
Date and time the parameter values were stored
Average operating temperature in buffer (actual value)
Cold water cooler PWC-C
outlet temperature (actual value)
Cold water cooler PWC-C
inlet temperature (actual value)
Unallocated sensor input
Preset cold water cooler-PWC-C
inlet temperature (target value)
Preset cold water cooler-PWC-C
outlet temperature (target value)
Status of process-medium pump
(off/on)
Status of circulation pump
(off/on)
Status of 230V output relay at plug contact 1
(closed/open)