Firmware Update - Kemper 611 00 Manuel D'utilisation

5.3

Firmware update

Data logger firmware update
5.3.1
Loading an update:
This is a special function (software update).
Please only carry out the update
when you are requested to do so
by the manufacturer!
Cold water cooler controller firmware update
5.3.2
Loading an update:
This is a special function (software update).
Please only carry out the update
when you are requested to do so
by the manufacturer!
© www.kemper-olpe.de – 07.2020 – K410061100000-00 – 21/64
1. Copy the firmware.bin file directly to the
SD card. The file must not be saved in a
subfolder.
2. Insert the SD card into the SD card slot of
the data logger.
3. Restart the data logger while holding
down the reset button until the LED
rapidly flashes red and yellow.
4. When the update is complete, the LED
will light up green, and the data logger
will run with the new firmware in normal
operation.
5. Delete the firmware.bin file from the
SD card again.
1. Creat the subfolder "update" on the SD
card.
2. Place the .bin file in the subfolder you've
created.
3. Insert the SD card into the data logger.
4. Restart the controller.
5. Update Confirm the update and leave
the controller switched on.