Operating Instructions; Unpacking The Appliance; Maintenance And Care - Thomas CENTRI 772 SEK Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Pull out the plug
– if the appliance malfunctions during operation;
– before cleaning and maintenance;
– after use.
Operate the spin dryer only in an upright position on
an even floor and maintain a distance of about 50 cm
from the wall or other objects (Fig. B, Page 5).
During operation, do not lift, carry, hold, move or tip
over the appliance.
Never handle the operating lever and lid with force.
Lift or carry the appliance by the carrying handles only.
Before disposal of the spin dryer, cut off the mains ca-
ble. Ensure that the appliance is disposed of carefully
and orderly.

Operating Instructions

Congratulations on your new purchase
We recommed that you read these instructions care-
fully in order to quickly become familiar with your new
appliance.
A good appliance, which is used properly, will serve
you for many years.

Unpacking the appliance

Dispose of packing materials in accordance with local
regulations.
Check the spin dryer for any transport damages, which
must be reported to the forwarding agent or goods
office responsible within 24 hours. In case of damage,
kindly send all relevant paperwork to the Thomas
Customer Service for further treatment.
Preparation for Use
1. Put the operating lever in the "OFF" position.
2. Open the lid.
3. Remove the transport safeguard from inside the
spin drum.
4. We recommend that the spin drum be washed out
with a standard detergent before using for the first
time.
5. Place the spin dryer on a level floor at
a distance of about 50 cm away from the wall
or other objects. Never balance out irregularities
in the floor surface by laying wood, paper or similar
materials under the appliance.
Loading the machine
1. Place a sufficiently large container for
excess water under the outlet spout.
2. Plug the appliance in to a mains socket (please
observe the Points of Safety).
3. Place each article of laundry singly in the
spin drum. Distribute the washing evenly in
the drum and press down firmly, so as to avoid
leaving empty spaces (and thus avoiding excessive
vibration of the machine during operation).
4. Do not place rolled-up items of clothing
(e.g. jeans) in the spin dryer.
5. Press the loaded washing down, so that there
is a gap of at least 3 cm between the washing
and the top edge of the drum. Lastly, cover the was-
hing with a cloth, the ends of which should be tucked
well down inside the drum, so as to avoid items of
washing being catapulted out during operation.
6. Close the lid.
Switch on the appliance
Turn the operating lever to the right as far as it
will go to the "ON" (I) position.
The spin dryer is now in operation and water flows out
of the outlet spout.
Spin Drying Times
 For normal washing: 3-5 minutes.
The residual moisture amounts to:
approx: 65% in machines with a spin speed of
1400 rpm;
approx: 40% in machines with a spin speed of
2800 rpm;
 For washing which requires no ironing:
15-30 seconds max.
Switch of the appliance
When water ceases to flow out of the outlet spout,
or when the spin process is to be terminated, turn the
operating lever back to the left to the "OFF" position.
When the drum has come to a standstill, open the
lid. A special safety device prevents the lid being
opened before the drum has stopped spinning.
Never force the lid open
Remove the laundry from the drum.
A
Gently tilt the spin dryer forward, so that any
remaining water can flow out of the outlet spout.
Pull out the plug.

Maintenance and Care

 Always pull out the plug before cleaning the
B
appliance!
 After use, wipe the spindrum dry with a cloth.
 If dirty washing has been spun, it is necessary to
E
C
F
D
A
E
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Centri 775 secCentri 776 secCentri 776 sek

Table des Matières