Change Of Door Opening Direction; Electrical Connection - FUST TF 050.2-IB Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB

Change of door opening direction

Should the setting-up or handling demand it, door-
opening direction can be refitted from right-handed to
left-handed.
Following operations are to be done on the basis of
figures and explanations:
Break the circuit of the appliance.
Take the covering of top door holder off, unscrew
the screws fixing the top door holder (2 pieces) and
take it off according to figure.
Take the door off.
Remove the screw fixing the lower door holder and
the other screw fixing the lower door holder and the
foot. Then remove the door holder and the foot as
shown in the Figure.
Loosen the screw fixing the foot opposite the lower
door holder in order to remove the foot.
Fix the door holder and the corresponding foot on
the opposite side and then the other loosened foot
at the former place of the door holder as shown in
the Figure.
Please make sure to place the lower foot
below the door holder. The lower foot is
recognizable by its 4 ribs on the outer surface.
Fit the door to the lower door holding pin.
To fit top door holder remove plastic coverings of
door holder holes carefully (e. g. with a knife) and
put them on the other side.
Fix top door holder with 2 screws in the place set
free being careful that the edge of the door is
parallel with the side of cupboard.
Put the covering of top door holder back.
Put over the handle and the plastic nails on the
other side.
In case you do not want to perform the procedures
above, call the nearest brand-mark service.
Technicians will accomplish the refitting expertly for
charge.

Electrical connection

This refrigerator is designed to operate on a
230 V AC ( ~ ) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to
get an electrician to fit an earthed socket in
compliance with standards near the refrigerator.
48
This appliance complies with the following
E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive)
and subsequent modifications,
89/336 EEC of 03.05.89 (Electromagnetic
Compatibility
Directive)
modifications,
96/57 EEC - 96/09/03 (Energy Efficiency
Directive) and its subsequent amendments.
and
subsequent

Publicité

Table des Matières
loading

Table des Matières