Maintenance; Cleaning; Grease Filters - ETNA AP360ZT Mode D'emploi

MAINTENANCE

Cleaning

Grease filters

Attention! Before performing any maintenance operation, isolate
the hood from the electrical supply by unplugging the appliance or
switching off your household's master switch. The cooker hood should
be cleaned regularly (at least as frequently as the grease filters are
cleaned) both internally and externally. Do not use abrasive products.
Do not use alcohol!
Attention! Failure to comply with the basic recommendations for
cleaning the cooker hood and cleaning/replacing the filters may lead to
a fire. Therefore, we recommend that you observe these instructions.
The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or failure
to observe the above safety recommendations.
Cooker hood
Clean the cooker hood with soapy water and a soft cloth. Then wipe
with clean water to rinse. Do not apply aggressive cleaning agents such
as caustic soda. The paintwork on the cooker hood will remain shiny if
it is periodically rubbed with wax.
Metal grease filters
These must be cleaned once a month (or when indicated by the filter
saturation indication system, if present on your model) using non-
aggressive detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle. The openings must be
placed downwards to let the water run out of the filters. When washed
in a dishwasher, aluminium grease filters may be discoloured slightly.
This is normal and does not affect their filtering capacity.
Removing the grease filters
Switch off the electricity! Remove the plug from the mains socket or
turn the switch in the meter cupboard to zero. Pull the grease filter
towards you and tilt it forwards and down.
EN 7