Marq REZOTUBE PACK Guide D'utilisation page 5

Setup
Note: Items not listed under the Introduction > Box Contents are sold separately.
Power Information
Before connecting the control box to a power outlet, make sure the power cable is not crimped or
damaged. Also, make sure the power outlet's voltage is within the range stated on this product (on
its housing or decal).
Before cleaning or replacing the fuse, disconnect RezoTube Pack from its power source. Use a
screwdriver or other tool to remove the compartment (do not pull it out by the tab only). Replace the
fuse only with a new fuse with the same rating (250 V, 2 A).
Mounting/Rigging
Standing
You can attach the tubes to their single mounts or to the 5-tube fan mount. To do this, align the pins at
the base of the tube with the pinholes of the mount. Turn the tube a 1/4 turn to secure it in the mount.
1 2 3
Place the mount/mounts on a flat, stable surface. Make sure all cables are secured and placed so
that no one will trip over them.
Place the control box on a flat, stable surface, or use screws to attach it to the wall using its rack ears.
5