Marq REZOTUBE PACK Guide D'utilisation page 4

Features
Control Box Rear Panel
1. Power In: Use a standard power cable
(included) to connect this input to a power
outlet.
2. Fuse: This compartment holds the fuse.
Before cleaning or replacing the fuse,
disconnect RezoTube Pack from its power
source. Use a screwdriver or other tool to
remove the compartment (do not pull it out
by the tab only). Replace the fuse only with a
new fuse with the same rating (250 V, 2 A).
3. Power Switch: Use this switch to power RezoTube Pack on/off.
4. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)
to another control box that will pass DMX data through it to this one. RezoTube Pack receives
DMX data over this connection. Please see
multiple control boxes.
5. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional control box.
RezoTube Pack sends its data to an additional control box over this connection. Please see
Setup > Linking > DMX
6. Art/Kling Net In: Use a Category 6 Ethernet cable (also known as Cat 6 or Gigabit Ethernet) to
connect this input to (A) your gigabit switch or (B) to another control box that will pass Art Net or
Kling Net data through it to this one. Please see
more information about linking multiple control boxes.
7. Art/Kling Net Out: Use a Category 6 Ethernet cable (also known as Cat 6 or Gigabit Ethernet)
to connect this input to an additional control box. RezoTube Pack sends its data to an additional
control box over this connection. Please see
information about linking multiple control boxes.
Control Box Top Panel
8. Display: This display shows messages and
values indicating the current status of the
control box.
9. Menu: Press this button to access RezoTube
Pack's menu.
10. Up: Press this button to select the next-highest
menu option or to increase the value by 1.
11. Down: Press this button to select the next-
lowest menu option or to decrease the value
by 1.
12. Enter: Press this to confirm your current
selection or value.
13. DMX: This light will illuminate when RezoTube Pack is receiving DMX data properly through its
DMX In.
14. Outputs: Connect the cable of each tube to each of these outputs. Make sure all cables are
secured and placed so that no one will trip over them.
4
Setup > Linking > DMX
for information about linking multiple control boxes.
3
1
2
Setup > Linking > ArtNet™/Kling-Net™
Setup > Linking > ArtNet™/Kling-Net™
8
9
11 12
10
14 14 14 14 14
4 5
6 7
for information about linking
for more
13
for