c. Optical mode:
➢ If the source of your devices has digital connectors, using them will improve the audio quality.
Optical cable is not supplied
➢ Remove the cap of the optical cable and check the direction of the plug before inserting it into the
connector.
➢ Connect the end of the optical cable to the rear of the sound bar and the other end to the optical
output of your TV (or digital device etc.).
➢ Turn on the sound bar and switch to OPTICAL mode
d. Coaxial mode:
➢ If the source of your devices has digital connectors, using them will improve the audio quality.
Coaxial cable is supplied
➢ Connect the coaxial jack on the back of the unit to coaxial out jack of your TV (or digital device etc.)
by a supplied cable.
➢ Turn on the unit and switch to coaxial mode.
e. AUX mode:
➢ Keep the unit powered on.
➢ Plug one end of the 3.5 mm AUX cord to the headphone jack on your device;
➢ Plug the other end of the 3.5 mm AUX cord into the AUX jack on the speaker;
➢ It successfully joins into the AUX Mode along with AUX icon lights up;
➢ Use the connected device's audio controls for music playback.
f. USB mode:
➢ Turn on the unit. Push USB disk with MP3 music files into USB port, it will switch to USB Playback
Mode and then start to play music automatically.
g. Automatic standby
If the sound bar remains idle (no signal input) for about 15 min, it will shut down automatically;
After about 240 mins continuous playback time, the sound bar will shut down automatically;
During normal use of the sound bar, make sure to set the amount of volume from sound
bar and external devices (such as DVD, TV, or mobile phone) at normal volume, if the
volumes in sound bar or external devices are indeed low, the sound bar may not detect
the input signal and it will power off the sound bar automatically
To deactivate the automatic standby, press and hold the USB button on your remote control for
about 3 seconds. The LED will simultaneously change to RED - GREEN – BLUE.
36