Manual Regeneration; Salt Lack Alarm Acknowledgement; Power Cut; Standby Mode - CPED INITIAL Mode D'emploi

Manual regeneration

At any time, it is possible to trigger the regeneration of the softener, via the long push (5 seconds)
on the êR key.
If this is done for a test purpose, it is possible to manually go from one step to the next by briefl y
pushing the êR key.
Salt alarm acknowledgement
When no salt is left in the tank, the device displays the alternate words SALT and CHECK.
Once the salt refi ll is done, you may just wait for the next regeneration to let this alarm disappear. It
is recommended though to acknowledge immediately the alarm, following these steps:
• Proceed with a long push (5 seconds) on the Menu key
• Then briefl y push this Menu key to go through the menus until the display shows this one:
• Push once on êR or
• Push Enter to confi rm
• Push Menu during 5 seconds to quit the menu: the alarm shall disappear

Power cut

In case of a power cut during a regeneration, this process restarts at the beginning of the ongoing
step. In case of a power cut during service, the softener will restart also in service.
Stand-by mode
It is possible to prevent the softener from going through a regeneration, automatic or manual. This
might be useful, for example, while you are waiting for the intervention of a technician in case of
technical problem. Therefore:
• Proceed with a long push (5 seconds) on the Menu key
• Then briefl y push this Menu key to go through the menus until the display shows this one:
• Push once on êR or
• Push Enter to confi rm
The display shows then the message STD-BY alternating with the softener autonomy value.
To cancel this function, you just have to come back to this STAND-BY menu and turn the lower line
into Off .
Accessed by the code 23, then the browsing works in the same way as the regular setting mode.
The intervention on the advanced setting shall be done by a trained professional. Any mistake can
disturb the work of the device and is under its author's responsibility.
CHECK / SALT (alternate)
On
é
key to make Off appear on the lower line
STD-BY
Off
é
key to make On displayed on the lower line

ADVANCED SETTING

Manual SOFTENER FER27-A6X code P0011148 - Rev 1 - 15/03/2017 27