Panasonic TY-CE103PS10 Manuel D'installation page 18

Assembly
1. Install the base
Install one prepared base
1. Insert the column
2. Fasten in place with two prepared M8 bolts (60 mm)
nuts .
3. Fasten in place with one prepared M16 bolt
• The bolt should be securely tightened to the torque given
below.
M16 bolt
M8 bolt
2. Install plates
Install prepared plates
1. Fasten prepared plates
bolts (60 mm)
Three plates
• The bolt should be securely tightened to the torque given
below.
12~14 N•m
3. Install onto the Plasma Display.
Install each column assembled in the above step 2 onto the
display.
(Note)
Each column should be installed so that the L/R label
affixed to it faces outside.
1. Prepare six sets of one M16 bolt
one plain washer
shown in the right figure.
2. Place each column on the display, and temporarily fix it with
prepared bolts from the top down.
3. Confirm that the each column has been properly seated on the
display, and then tighten the bolts securely.
• The bolt should be securely tightened to the torque given
below.
25~35 N•m
18
(vertical hanging)
on the column .
on each column
between the side plates of the base
25~35 N•m
12~14 N•m
on the column .
on each column
to the column
and nuts .
should be installed.
, one spring washer
, which should be assembled in the order
.
.
and
.
Install the base
surface of the column to which the gaskets
have been attached facing down.
.
with prepared M8
Prepared M8 bolt
(60 mm)
and
Prepared
M16 bolt
3
1
2
Prepared M8 bolt
(60 mm)
on column
Prepared plates
1
2
Column
3
Plasma Display
with the