Makita 6940D Manuel D'instructions page 5

ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
1
2
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions
above.
Adjusting the angle head
1
2
001266
9 mm
(3/8")
002824
1. Bit
2. Sleeve
002826
1. Hex bolt
2. Angle head
1
The angle head can be adjusted 360°(8 positions in 45-
degree increments). To adjust it, loosen the hex bolt and
remove the angle head.
Adjust the angle head to the desired position and rein-
stall it so that the teeth on the housing will match up with
the grooves in the angle head. Then tighten the hex bolt
to secure the angle head.
Straight head and ratchet head
(optional accessory)
Straight heads and ratchet heads are available as
optional accessories for various applications on the job.
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. Before starting your job,
always perform a test operation to determine the proper
fastening time for your screw.
NOTE:
• Use the proper bit for the head of the screw/bolt
that you wish to use.
• Hold the tool pointed straight at the screw.
5
002827
1. Groove
2. Tooth
2
002828
1. Straight head
1
002829
1. Ratchet head
1