Troubleshooting; Specifications - Insignia NS-1UCDVD Guide De L'utilisateur

Insignia NS-1UCDVD DVD Player

Troubleshooting

Problem Solution
No power. Make sure that the power cord is
plugged securely into the wall
outlet.
Power is on, but DVD player
does not work.
No picture.
No sound or distorted sound.
Can't advance through a movie. You can't advance through the
opening credits and warning
information that appears at the
beginning of movies because the
disc is programmed to prohibit
that action.
Picture is distorted.
Remote control does not work
properly or IR sensor is
inoperative.
Play starts, but then stops
immediately.

Specifications

Note
General:
Power requirements: . . . . . . . . . . 120 V AC, 60 Hz
• Insert a disc with the label
Power consumption:. . . . . . . . . . . . . . . . . . . . . 8 W
side facing up.
Dimensions (W x D x H): . . . . 17 x 1.4 x 7.9 inches
• Check the type of disc you
. . . . . . . . . . . . . . . . . . . . . . . . (430 x 35 x 202 mm)
put into disc tray. This
Weight: . . . . . . . . . . . . . . . . . . . . . . .3.5 lbs (1.6 kg)
player only plays DVDs,
Operating temperature: . . . . . . . 41~95°F (5~35°C)
audio CDs, MP3s, and
Operating humidity: . . . . . . . . . . . . . . . . . . . 5~90%
WMAs.
Compatible discs:. . . . . . . . . . . DVD/CD/MP3/WMA
• Make sure that all
Battery Type: . . . . . . . . . . . . . . . . . . . . . . . . . . AAA
equipment is turned on.
Outputs:
• Make sure the correct
VIDEO OUT: . . . . . . . . . . . . . 1.0 V (P-P), 75 ohms
video input mode is
(synch. negative, RCA jack x 1)
selected on the TV.
S-VIDEO OUT (Y):. . . . . . . . . 1.0 V (P-P), 75 ohms
• Make sure all cables are
securely inserted into the (synch. negative, Mini DIN 4-pin x 1)
appropriate jacks.
S-VIDEO OUT (C):. . . . . . . . . 0.3 V (P-P), 75 ohms
COMPONENT VIDEO OUT: . . . . . . . . . . . . . . . . . .
• Make sure the correct
input mode of the audio
receiver is selected.
• Make sure all cables are
securely inserted into the
appropriate jacks.
AUDIO OUT: . . . .2.0 Vms (1kHz, 0 dB), 600 ohms
• Make sure that all
equipment is turned on.
DIGITAL OUT (COAXIAL): . . 0.5 V (P-P), 75 ohms
• Make sure that the AUDIO
option is set to the correct
DIGITAL OUT (OPTICAL): . . . 3.0 V (P-P), 75 ohms
position, then press
POWER again to turn on
System:
the DVD player.
Signal system: . . . . . . . . . . . . . . . . . . . . . . . .NTSC
Laser: . . . . . . . . . . . . . . . . . . .Semiconductor Laser
Frequency response: . . . . . . . . . . . . . . . . . . . . . . . .
Harmonic distortion:. . . . . . . . . . . Less than 0.02%
• The disc might be
Dynamic range: . . . . . . . . . . . . . .Better than 95 dB
damaged. Try another
Signal-to-noise ratio: . . . . . . . . . .Better than 90 dB
disc.
• It is normal for some
distortion to appear
during forward or reverse
scan.
• Verify that the batteries in
the remote are fresh.
• Verify that the remote
sensor eye is not
obstructed.
• Verify that the infrared
transmitter is pointed
directly at the IR sensor,
and is within 10 feet of the
sensor.
• Both the player and the
disc are coded by region.
If the regional codes don't
match, the disc can't be
played.
• There is a parental lock on
the DVD player which
prevents DVDs with an
unacceptable rating to
play.
• The disc is dirty. Clean it.
• Condensation has formed.
Allow player to dry out.
www.insignia-products.com
Specifications are subject to change without notice or
obligation.
(Y): 1.0 V (P-P), 75 ohms
(synch. negative, RCA jack x 1)
(Pb and Pr): 0.7 V (P-P), 75 ohms
(RCA jack (L,R) x 1)
(PCM 96 kHz):. . . . . . . . . . . . . . . . 8 Hz to 44 kHz
(PCM 48 kHz):. . . . . . . . . . . . . . . . 8 Hz to 22 kHz
(CD): . . . . . . . . . . . . . . . . . . . . . . . 8 Hz to 20 kHz
(ANALOG OUT connectors only)
(RCA jack x 2)
(RCA jack x 1)
(Optical jack x 1)
17